Configure spindle enable

Hello
I am working with mesa 7i77 and Buster with 2.8 LCNC and need if it is possible to :
Enable spindle only when i give command M3 or M4 or when Spindle on is aktiv. I don't want spindle to be in enable state when i enable all axis. I have problem that spindle is spinning only a little when is in enable state. That is my zero offset not tuned correctly.. I do not have hooked up encoder to spindle.
I cannot find anything for this in this forum or manuals, or maybe i missed something..

Thanks to all

Should find some info here:
forum.linuxcnc.org/forum/search?query=7i...pindle&childforums=1

It also helps if you can throw up your hal & ini files so others can have a look & advise.

Thank you BeagleBrainz for quick replay.
Here are hal and ini.
Thanks

You should use analog out 5 for the spindle since it has a separate enable
HAL pin and enable output pins for that purpose.

With analog out 5 working Great with spindle

Thanks PCW