pend+ pend- In-position Signal from stepper closed loop driver HSB86H

More
5 years 11 months ago #189408 by alkabal
pend+ pend- In-position Signal from stepper closed loop driver HSB86H was created by alkabal
Hi
The driver HSB86H (and i think others) allow to connect a in-position signal to host

Can i ask if this can be useful and what is the HAL signal to link ? (i thin unrelated but card is mesa 7i76e)

Br

Attachment not found

Please Log in to join the conversation.

More
5 years 11 months ago #189462 by alkabal
Replied by alkabal on topic pend+ pend- In-position Signal from stepper closed loop driver HSB86H
I foudn the answear : this output is designed for use with some standalone controller and is not wanted for Linuxcnc.

forum.linuxcnc.org/49-basic-configuratio...closed-loop-steppers

Br

Please Log in to join the conversation.

Time to create page: 1.733 seconds
Powered by Kunena Forum