preempt rt buster iso Mesa problem

More
5 years 6 months ago #205138 by jsskangas
Replied by jsskangas on topic preempt rt buster iso Mesa problem
OK

LinuxCNC 2.8.0 Debian 10 Buster PREEMPT-RT ISO does not recognize 6i25 mesa card.

Can I fix this?
if then how?

Please Log in to join the conversation.

More
5 years 6 months ago #205144 by PCW
Replied by PCW on topic preempt rt buster iso Mesa problem
Which PC hardware works and which doesn't?

Note, the card is recognized but LinuxCNC has insufficient privileges to:

1. Setup real time priorities (this is why it says its using POSIX non-realtime)

2. Allow driver access to memory

Please Log in to join the conversation.

More
5 years 6 months ago #205146 by jsskangas
Replied by jsskangas on topic preempt rt buster iso Mesa problem
Doaloaded from linuxcnc.org -->
LinuxCNC 2.8.0 Debian 10 Buster PREEMPT-RT ISO

Fresh install does not recognize mesa 5i25.

Please Log in to join the conversation.

More
5 years 6 months ago #205147 by PCW
Replied by PCW on topic preempt rt buster iso Mesa problem
The 5I25 card _is_ found but as I said,

LinuxCNC is unable to:

1. Setup real time priorities (this is why it says its using POSIX non-realtime)

2. Allow driver access to memory

What is the difference between the PC hardware that works and the PC hardware
that has the permissions issues?

Please Log in to join the conversation.

More
5 years 6 months ago #205148 by jsskangas
Replied by jsskangas on topic preempt rt buster iso Mesa problem
I tried to with halrun in command line:

Attachment not found



No luck.

Please Log in to join the conversation.

More
5 years 6 months ago #205149 by jsskangas
Replied by jsskangas on topic preempt rt buster iso Mesa problem
It is a same pc same hardware.
No difference, same setup worked before updating to buster.
After new install from iso file, same setup just dont work.

Please Log in to join the conversation.

More
5 years 6 months ago #205150 by PCW
Replied by PCW on topic preempt rt buster iso Mesa problem
OK that's a different error (not the permissions issue)

Did you do a

halrun -U

before running the test to make sure you don't have
leftovers from a previous test loaded?

Please Log in to join the conversation.

More
5 years 6 months ago #205153 by PCW
Replied by PCW on topic preempt rt buster iso Mesa problem
What PC hardware does the buster installation fail on?

Please Log in to join the conversation.

More
5 years 6 months ago #205155 by jsskangas
Replied by jsskangas on topic preempt rt buster iso Mesa problem
i7 asus main board nothing special or fancy,

Please Log in to join the conversation.

More
5 years 6 months ago #205158 by tommylight
Replied by tommylight on topic preempt rt buster iso Mesa problem

jsskangas wrote: Is LinuxCNC 2.8.0 Debian 10 Buster PREEMPT-RT ISO compatible with 6i25-7i77 combo of the box?

Yes it is.

Please Log in to join the conversation.

Time to create page: 0.883 seconds
Powered by Kunena Forum