hy vfd rs 485 gmoccapy

Search for "arduino usb permission denied".

italy

Tommy, do you use a locale other than English when you set up machines?  (Especially ones where thc-feed-rate remains zero despite being on a later version of QtPlasmaC)?  

sorry to “borrow” this thread, but since it came up here…

tommylight wrote:

Search for "arduino usb permission denied".

I tried to run on live debian, then I had an error: permission denied. After installation it allows to use USB`s
 

snowgoer540 wrote:

Tommy, do you use a locale other than English when you set up machines?  

What should i use? Albanian is not an option !
Nah, always English, even keyboard is always English despite having all kinds of layouts.

Pauchuk wrote:

tommylight wrote:

Search for "arduino usb permission denied".

I tried to run on live debian, then I had an error: permission denied. After installation it allows to use USB`s

 

It will still not work on Linux, the current user has to be added to the "dialout" group.

tommylight wrote:

Pauchuk wrote:

tommylight wrote:

Search for "arduino usb permission denied".
I tried to run on live debian, then I had an error: permission denied. After installation it allows to use USB`s

 

It will still not work on Linux, the current user has to be added to the "dialout" group.

$ getent group dialout
dialout:x:20: my user name..
So, this is done too..

Just got another HY VFD, same thing. So up until now, I have used 2 PC`s, linuxcnc 2.7, linuxcnc with update, linuxcnc 2.8 and got same error - error reading setup from VFD.. What should I do next?

I presume you can see your RS485 adaptor with terminal command?

Aciera wrote:

I presume you can see your RS485 adaptor with terminal command?

Code:

lsusb Command not found. I tried apt-get install usbutils Gives me: 'usbtutils' has no installation candidate.. I run

sudo apt-get update and then, again apt-get install usbutils, same error - no candidate