VistaCNC P4-SE velocity mode stopped working after update to 2.8

More
4 years 8 months ago #234829 by cheburs
Replied by cheburs on topic VistaCNC P4-SE velocity mode stopped working after update to 2.8
Just made an small video - photos.app.goo.gl/K4qpXrn5azqrAEGi6

The button just freezes.
When disabling pendant in ini file, then Z moves and starts to find limit switch.
 

Please Log in to join the conversation.

More
4 years 8 months ago #234831 by cheburs
Replied by cheburs on topic VistaCNC P4-SE velocity mode stopped working after update to 2.8

Attachment not found



There was no additional lines in terminal when homing joint 3.

Please Log in to join the conversation.

More
4 years 8 months ago #234835 by Clive S
Replied by Clive S on topic VistaCNC P4-SE velocity mode stopped working after update to 2.8

Attachment not found



There was no additional lines in terminal when homing joint 3.

If you look at the screen shot it shows the error warnings hal line 2 dos style endings

Please Log in to join the conversation.

More
4 years 8 months ago #234839 by cheburs
Replied by cheburs on topic VistaCNC P4-SE velocity mode stopped working after update to 2.8
Saved as new file in gedit with linux line ending. There is no more DOS style error, but it didnt resolve homing problem.

Please Log in to join the conversation.

More
4 years 8 months ago #234841 by cheburs
Replied by cheburs on topic VistaCNC P4-SE velocity mode stopped working after update to 2.8
Error was in vc-postgui.hal file. Had to comment out axis3 and onwards.

Now i can home.

Please Log in to join the conversation.

Time to create page: 0.106 seconds
Powered by Kunena Forum