What is Maximum Number of Axis in Linuxcnc.

More
4 years 10 months ago #229973 by Luckyind
What is Maximum Number of Axis in Linuxcnc. was created by Luckyind
Can Linuxcnc run an 8 axis system. I am trying to control a suspended cable robot and it has 8 servos. 

Please Log in to join the conversation.

More
4 years 10 months ago #229979 by tommylight
Replied by tommylight on topic What is Maximum Number of Axis in Linuxcnc.
LinuxCNC can control 9 axis, each of those axis can have more than one joint/motor (8 i think), so that is the easy part.
Might have to figure out kinematics, but Delta might be a good start.

Please Log in to join the conversation.

Time to create page: 0.390 seconds
Powered by Kunena Forum