7i96 configuration Tool and Gantry XYZ Machines

I think I can get to this on thursday.  Off to the big smoke tomorrow and today is tied up.  Otherwise the weekend for sure

any luck ??

Rnjfab

been terribly busy but i did manage to cut my first paying gig under the LINUXCNC flag.  I am very pleased overall.  just about all issues i was having with my aging Mach3 setup have gone away.  Added bonus is that i am able run the machine faster with the linux setup.  Once the i got motion very easy to setup.  Thanks for your help.

BigJohnT i tried to follow the instuctions to reload the tool but i get a message that says it is the same version that i have loaded. Am i looking in the wrong place. the file says it is 1.3.4 yet when i run it. It says it is version 1.3.2

I got another issue in that i moved the equipment out to the shop now and i do not have the internet out there right now. II am working on it. so i may go a little slow getting this tested.