I've recently updated from 2.8 to 2.9.2 and I'm having issues with the homing of my dual y axis that uses a single limit switch (i'll be adding a second one for auto squaring in the future). Since migrating the Y axis will go to home and them give a switch triggered while in home state 10 error. I've tried adjusting a number of the homing options but none of them resolve the issue. So I'm wondering if there been any changes since 2.8 that would require this setup to be configured differently.
NOTE: I am using a 7i76E and I've attached my config and hal file for reference.
