8200/8300 SFF with linuxcnc

I have a small number of these with debian stretch / Linuxcnc (rt_preempt) installed.
Comes with
2nd/3rd gen i5 (depending on stock - they both perform similarly...)
Wireless usb dongle that works with linux
4GB ram
On board printer port
Few kernel line tweeks (idle=poll and isolcpus=3)
On board Ethernet setup for mesa (set to 10.10.10.2 static)
Bios setting tweeked (turning off amt/power saving and such)

Really good latency - Have had it run 40khz out of the printer port (see videos)



www.ebay.com/usr/samcoinc?_trksid=p2047675.l2559

hi
lots of tweeking
what are the numbers on a standard non tweeking
and as it is a International channel
please more infos on the board itself

I can run the test - give me a day or two...

pl7i92 wrote: please more infos on the board itself

It's a Dell enterprise PC, all the info for the board is already on the Dell website.