Okuma MV45VBE Vertical Milling Center-Electrically Abused

This machine is still available. Todd, are you still interested? If so, email me jacob.thomas@JTmachineservices.com and we'll get together on it.

It won't last much longer, as the trailer is going to be needed soon.

I think it is just a little too far for us to gamble the time to go look at it (considering the condition of it in the photos.) Thanks

If someone connected it to wrong power couldn't you get insurance money for it?

Probably fried the Transformer. If lucky nothing else was cooked.

What power does it require?

This machine requires 220V 3 Phase, and was hooked to 480V 3 phase.

I would imagine there is quite a bit of power supply burned up inside, anything connected to double the normal voltage or configured voltage would have a very bad time.

As to insurance money, insurance isn't going to pay out enough to repair something like this. Even if they did, the cost increase in premiums paid would make it a difficult decision.