Where is the calculator in linuxcnc 2.7.3?

I've looked through every pull down menu available and there is no calculator to be found? I can't believe that there wasn't a calculator included in the build so where would that little sucker be hiding?

Thanks,
Dave

LinuxCNC does not have a calculator. I assume you meant the OS your using like Debian Wheezy.

JT

Davenc wrote: I can't believe that there wasn't a calculator included in the build so where would that little sucker be hiding?

Slightly bizarrely there actually isn't a calculator in the default Debian install. (other than the command-line one)

If you go to the Synaptic package manager (System->Synaptic Package Manager) then you can install one easily.

"gcalctool" is probably the one you were expecting to find.