Debian Uspace

What is the current Debian version to use with Uspace? What RT preempt kernel do you use? Just trying to navigate the Debian website is a nightmare if your looking for something other than the current version... however I finally stumbled onto this page cdimage.debian.org/cdimage/unofficial/no...-including-firmware/ which has all the versions.

JT

I have been using the experimental version here

www.linuxcnc.org/testing-stretch-rtpreempt/

I have used it on a few systems with no issues (using it on my main laptop too)

sam

packages.debian.org/stretch/linux-image-rt-amd64
or
packages.debian.org/stretch/linux-image-rt-686-pae

Thanks, I work on that in the morning during free d/l time.

JT

Todd Zuercher wrote: packages.debian.org/stretch/linux-image-rt-amd64
or
packages.debian.org/stretch/linux-image-rt-686-pae

I installed Debian i386 Mate then did and update.

I went to packages.debian.org/stretch/linux-image-rt-686-pae and don't see how to get the deb. I clicked on the dep: linux-image-4.9.0-5-rt-686-pae link but got "Internal Server Error

The server encountered an internal error or misconfiguration and was unable to complete your request.

Please contact the server administrator at webmaster@debian.org to inform them of the time this error occurred, and the actions you performed just before this error.

More information about this error may be available in the server error log."

Following the manual I got this error
"sudo apt-get install linux-image-rt-686-pae
[sudo] password for emc:
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Unable to locate package linux-image-rt-686-pae
"

JT

That is strange, I just did a test install of Debian 9 (Mate DE) on a VM using the net install iso. Then using Synaptic, linux-image-4.9.0-5-rt-686-pae installed just fine. (I did not bother trying it with atp-get.)

I'll try that or Synaptic in the morning and see what I get.

Thanks
JT

Then I installed Linuxcnc and that seemed to work without a hitch. Once I got the Linuxcnc repositories set up and the keys installed. (I did have a little trouble installing the keys.)

Todd, thanks for the help. Took a while to get the LinuxCNC deb added to the Synaptic Package Manager, they changed the interface and now it's a two step ordeal to get one added. They don't have add-app-repository anymore lol. Anyway the net install did have the rt kernel so I'm up and going with that.

Thanks
JT

Hey JT,

You can add the software-properties-common (sudo apt install software-properties-common) and that adds the command.!

Thanks,
Omid