password

More
8 years 8 months ago #105851 by deslee848
password was created by deslee848
hello,need some help,i just install linuxcnc 2.7. it keep asking wrong password.can some one tell me what went wrong

Please Log in to join the conversation.

More
8 years 8 months ago #105852 by Todd Zuercher
Replied by Todd Zuercher on topic password
It is a common mistake with the Wheezy based install (been there, done that, have the T-shirt). The first login prompt is for your username (It only says Login), the next prompt is for your password. If you enter your password at the username prompt by mistake, what ever you enter in the subsequent password prompts will never be correct.

Please Log in to join the conversation.

Time to create page: 0.188 seconds
Powered by Kunena Forum