Installing LinuxCNC on Debian 9

More
8 years 3 months ago #113960 by BigJohnT
Here is the method I use to install LinuxCNC on Debian 9 and setup for using an Ethernet Mesa card.

gnipsel.com/linuxcnc/uspace/debian9-rt.html

gnipsel.com/linuxcnc/uspace/debian9-emc.html

gnipsel.com/linuxcnc/uspace/debian9-eth.html

I've gathered all my instructions into one place for Uspace and various OS's

gnipsel.com/linuxcnc/uspace/

JT

Please Log in to join the conversation.

More
8 years 3 months ago #114024 by Grotius
Hi John,

Why not cloning a pre configured debian 9 with clonezilla server? clonezilla.org/clonezilla-SE
This saves time.... I only tried the cd clonezilla, this works perfect. 15 minutes ready.
Is this an idea to use?

Please Log in to join the conversation.

More
8 years 3 months ago #114035 by BigJohnT
I guess once you setup the drive cloning it might be a good thing.

JT

Please Log in to join the conversation.

More
8 years 3 months ago #114044 by tommylight
Or use "SystemBack" that is very friendly and easy to use.
In some cases you have to uninstall casper and install liveboot, but otherwise it works nicely and can also make an ISO that can be booted from a USB.

Please Log in to join the conversation.

More
8 years 2 months ago #115574 by Vitran
cdimage.debian.org/cdimage/unofficial/no....0-amd64-netinst.iso

This link you provided is only a few days old, but it is giving a 404 Not Found. Where can one find where the disk images are?

Please Log in to join the conversation.

  • AnnoyingMutt
  • New Member
  • New Member
More
8 years 2 months ago #115593 by AnnoyingMutt

Please Log in to join the conversation.

More
8 years 2 months ago #115599 by Vitran
That works, thank you. Yesterday it was providing a 404 when I copied BigJohnT's link no matter what I tried, but I was doing it on a different computer.

Please Log in to join the conversation.

More
8 years 2 months ago #115605 by BigJohnT
I should have known better than to put the file name in the link... it will change.

JT

Please Log in to join the conversation.

More
7 years 11 months ago #121076 by Mya2k
Hello,

The link seems to be broken as of 11/20/18. Please refer to attached image. Also, is it expected that the www.linuxcnc.org domain is down?

Thanks,
Mya

Please Log in to join the conversation.

More
7 years 11 months ago #121136 by andypugh
Looks like a problem at your end, both linuxcnc.org and cdimage.debian.org/cdimage/unofficial/no...-including-firmware/ are working for me.

downforeveryoneorjustme.com can be a useful way to check.

Please Log in to join the conversation.

Time to create page: 0.113 seconds
Powered by Kunena Forum