ROLL BACK TO PREVIOUS 2.8 VERSION

More
7 years 11 months ago #120866 by COlger81
ROLL BACK TO PREVIOUS 2.8 VERSION was created by COlger81
Can someone provide a link to where i can download an older version of 2.8? pre1-4040 has many Gmoccapy issues. Seems like some drastic changes were pushed through in Gmoccapy the other day in a hurry.

Please Log in to join the conversation.

More
7 years 11 months ago #120868 by Todd Zuercher
Replied by Todd Zuercher on topic ROLL BACK TO PREVIOUS 2.8 VERSION
You can use Synaptic to force the version easily.

(I'm certain there are ways using apt-get and the command line, but I'd have to look them up.

Please Log in to join the conversation.

More
7 years 11 months ago #120871 by cmorley
Replied by cmorley on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Since thee are no released versions of master(2.8), I'm pretty sure you would need to compile a particular version.

Chris M

Please Log in to join the conversation.

More
7 years 11 months ago #120883 by Todd Zuercher
Replied by Todd Zuercher on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Buidbot.linux has back to 2.8pre1-3932 right now. So if that is back far enough for you, you won't have to build from source.

Please Log in to join the conversation.

More
7 years 11 months ago #120886 by COlger81
Replied by COlger81 on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Thank you, i rolled back to 3932 and it works without issue.

Please Log in to join the conversation.

More
7 years 11 months ago #120997 by andypugh
Replied by andypugh on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Are the issues that you found mentioned in the bug-tracker?

Please Log in to join the conversation.

More
7 years 11 months ago #120998 by COlger81
Replied by COlger81 on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Norbert has already made the necessary fixes to code. It was a merge issue.

Please Log in to join the conversation.

More
7 years 11 months ago #121004 by COlger81
Replied by COlger81 on topic ROLL BACK TO PREVIOUS 2.8 VERSION
Also posted a question on this link.
forum.linuxcnc.org/10-advanced-configura...indle-gearing-config

Please Log in to join the conversation.

Time to create page: 0.534 seconds
Powered by Kunena Forum