(superseeded) Linuxcnc on Linux Mint 19.3 quick and easy installation

Can you paste the debug info, please.

WARNING:
Do not change the title of the topic when replying to it, please.
Had a shock when i saw a title i could not recognize started by me !!!

tommylight wrote: WARNING:
Do not change the title of the topic when replying to it, please.
Had a shock when i saw a title i could not recognize started by me !!!

It would be nice if that could be prevented...

How the hell does that happen ?
I can see the subject box, but wow changing a title doesn't seem right.

aaaaand it's back !!!
Now i have to edit the original post to set it back, again!
I agree that this should be prevented, it causes a mess for searching with the added load on the server when adding another copy of the same topic to the database.

Files now available, as usual tested in Vbox
md5: 86 bytes (86 bytes)
drive.google.com/open?id=1jcSdgUkSubGNo8oRt_acU_0sjqCFJZyN

iso: 2.3 GB (2340421632 bytes):
drive.google.com/open?id=17f4FhtF5hayFpumpNHrGFyJ0OQlRb9aT

Enjoy

Ok I have put the above on a stick using Win32DiskImager everything went to plan and just worked.

Q. What is the difference between the two iso's . ie the one above and the one from the 11th LinuxMint-19.2-LCNC-2.9-rt-4.16.12-kona-amd64

Thanks again for the hard work you are putting into this.

Clive S wrote: Q. What is the difference between the two iso's . ie the one above and the one from the 11th LinuxMint-19.2-LCNC-2.9-rt-4.16.12-kona-amd64

This one has working QTVCP already installed.

I'll try to do a change log type post when I through up a new version.

Next one, hopefully, will be a RTAI version. Had some issues with Andy's test linuxcnc packages relating to qtvcp designer. Posted up on the thread to see if there's some I screwed up.

Am currently building Linuxcnc 2.9 rtai packages and will see how it goes.

Once again big thanks to all who have downloaded the images and given them a twirl. Very much appreciated.

Cheers
Rob

Just downloaded the new iso, will give it a run later, right after i check Phill's.

No worries Tommy, should go all ok.
Should have the RTAI done tomorrow morning, finished compiling the 2.9 RTAI Linuxcnc packages, qtvcp designer runs ok.

Kinda glad I've setup a local repo for the packages, saves having to wait to get packages off the net.

Wonder if it's worth doing an XFCE version...............