Linuxcnc-ethercat: undefined symbol: ecrt_slave_config_sdo

Hi,

Ok i will try. I see download is around 30 minutes.

see last post. :whistle:

see last post. :evil: :evil:

Hi,

It's ready. "Linux Mint Rtos Stormhold"

link to your Distro

Hey Grotius

was it a no-nonsense installation process ?

Thank you very much, its amazing that you would take the time to do this :woohoo:

I tip my virtual hat to you sir

Hi Stromhold,

The new part was compiling a kernel inside a chroot environement.
Also the Crontab -e was doing 2 things at the same time. I mentioned this it later on.

was it a no-nonsense installation process ?

It wend welll. It's documented at github

Will give the Os a link at the os section of the forum.

I like the part : life goes on, starting at 20:11

Groti, you've gone soft !
Nice music, thank you, but i am in the mood for something much heavier.

Hello Grotius

Just wanted to share the fact that thanks to your image i am now up and running with ethercat, the image shows the hal configuration of the ethercat with a Delta MS300 VFD inverter.

Again thank you!

thanks it worked for me,
only one thing: first i found where is the location of libethercat.so files for me.
i mean these three files: libethercat.so.1, libethercat.so.1.1.0, libethercat.so

then i copied them to the /lib/x86_64-linux-gnu/

then by running your edited make file the problem solve.