Trying to Install LinuxCNC Probe Basic on a Zotac Zbox CI327

More
5 years 6 months ago #205686 by PhilCNC
Trying to Install LinuxCNC Probe Basic on a Zotac Zbox CI327 was created by PhilCNC
I'm having trouble getting the network part of the installion to finish. I'm always stuck on the "Configure the network" screen. I'm using a wired connection. Maybe I need to change a setting in the BIOS? Anyway, help is greatly appreciated!

Please Log in to join the conversation.

More
5 years 6 months ago #205737 by andypugh
Replied by andypugh on topic Trying to Install LinuxCNC Probe Basic on a Zotac Zbox CI327
Is this the stock installer, or something Probe-Basic specific?

Please Log in to join the conversation.

Time to create page: 0.125 seconds
Powered by Kunena Forum