Hi.
Was using the mill today after the Deb 10/Buster/LCNC 2.8.2 .iso install.
Linuxcnc was running at the time and after a while the screen went blank and I had to log in again to re-display Linuxcnc.
I have already entered the following:
sudo systemctl mask sleep.target suspend.target hibernate.target hybrid-sleep.target
to prevent any sleeping/hybernation...
but:
1. where/how do I disable the above from happening?
2. is what I have done via terminal sufficient or are there settings elsewhere to prevent sleeping or applying a screen lock?
Thanks!
