Axis Gui will no longer home X and Z (lathe)

Complete upgrade install. Went from Wheezy to Buster.  Used new Buster Live DVD. When homing the homing character will appear next to the appropriate axis however you can do nothing after that except jog the X and Z.  Anything else gives a homing error.  Axis Not Homed. Been using Axis for 14 years off and on with no problems.  Any ideas.  I am strictly a user and not a tinkerer or experimenter.  It is probably something simple, however I can find no answers in the places I have searched. Any help appreciated.

PS also loaded the TK??????? gui and could not home there either although it appeared to. Again homing errors.

Upload hal and ini files here on the forum, please.

Yes sir, Thank you . First thing in the morning. Just went through torrential rain and severe lightning storm.

Enclosed are configs dir and hallib dir 

Had to remove .gz ext to upload. Was .tar.gz 

Problem solved. Used default config without going through stepconf. It has been several years since using this machine and do not remember if I have ever installed without going through stepconf. I have installed on several computers over the last 14 years and this is the first time that this has occurred.

Thank you for your help. I should have thought of this yesterday.

Your existing configuration really ought to have "just worked"