upgrade from wheezy error on conversion

Hi guys,Thanks for your help. I guess I have a problem. I installed the new os and started linuxcnc with my old config files in my home directory. It tried to run the conversion but I think that failed. Can you help please?Thanks a bunch,Robert

The attached report does not belong to the attached ini file, base periods are not the same.
Attach the report generated by the ini/hal file in actual use.

Sorry,
Here you go... 

in section [JOINT_0] should be Notice the space before the dot, it is not allowed.
Just to make sure it is a conversion error, can you please copy the old config to another folder, like Downloads then try the conversion again.
Thank you.

Thanks... I checked the old ini on the wheezy partition and it has the space so I assume the conversion didn't make a mistake. Here are my files as they sit now...

Remove "(inches per second)" or put a # in front of them.

Thanks a bunch! commenting didn't work but removing it did! I'm in. You rock!