Installing LinuxCNC on other Linux distros does not work anymore

tommylight wrote:

./configure uspace no-docs
did not work for me.

Code:

nano ~/linuxcnc-dev/debian/rules OMIT LINE 32 >>>>> #enable_build_documentation = --enable-build-documentation=pdf CTRL+O enter CTRL+X

I just committed the change that fixed it a little over 12 hours ago. Curious, have you pulled since then and tried again? And if so, what was the error?

First run at 2AM, second at 3:20AM last night.
It is 5:30 PM now, so it is over 12 hours.
I plan on testing this again later.
Thank you.