Fresh Install, waiting for 7i96S and 7I85S few questions

Currently have a fresh install of Mint 21 and LinuxCNC 2.9 PRE. I should have the 7i96S and 7I85S some time next week. Going to be using this setup on a failed centroid setup on a lathe. I have one question right now, I do not see any other GUI other than Axis listed. Is this a symptom of using Mint 21? I have attached a few screen grabs. The install of Mint and LinuxCNC was very painless, No reason I picked Mint over anything else I just saw a quick how to on the forum using 2.9 and I will need 2.9 using the 7i96S card so I thought I would give it a shot before everything got here.

 
 

Menu>preferences>appearance>change to a white theme.

Done....My eyes! lol

Does this have anything to do with not seeing any other GUI except axis?

ConSonar wrote:

Done....My eyes! lol

Does this have anything to do with not seeing any other GUI except axis?


 

Quick reboot and it does. Fantastic.

Fro QTDragon and QtPlasmaC you might need to install some other stuff, and for that PhillC made a nice script that does everything in one go:
forum.linuxcnc.org/qtvcp/38414-installing-qtvcp