Debian 11 Bullseye Repositories

Does somebody, anybody have the proper and correct repositories for Bullseye Debian 11?

Including of course for LinucCNC ????

Thanks.
 

Maybe Rod can help, but in the meantime, i am sure BullsEye does not have LinuxCNC repositories, the BookWorm does, and that is still not official.

You are better off skipping bullseye in favour of Bookworm as it has linuxcnc included as packages. Bullseye will require building linuxcnc from source but this script automates it:
github.com/joco-nz/lcnc-bullseye-installer

I'd start with the Bookworm alpha ISO  cdimage.debian.org/cdimage/unofficial/no...-including-firmware/
then you will find linuxcnc-uspace in synaptic. or
sudo apt install linuxcnc-uspace

 

These work pretty well.  took a bit of searching...

deb     deb.debian.org/debian/ bullseye main  contrib  non-free
deb-src deb.debian.org/debian/ bullseye main  contrib  non-free

deb     security.debian.org/debian-security bullseye-security main contrib  non-free
deb-src security.debian.org/debian-security bullseye-security main contrib  non-free

deb     deb.debian.org/debian/ bullseye-updates main contrib  non-free
deb-src deb.debian.org/debian/ bullseye-updates main contrib  non-free

 

They look like the standard settings for Bullseye.
You will need to build linuxcnc from source as there is no buildbot debs for bullseye.

Rod,
aren't you following what Seb K is doing????

buildbot2.highlab.com

 

I was not aware of that.

Roguish wrote:

Rod,
aren't you following what Seb K is doing????

buildbot2.highlab.com

 
 
 

Any chance for an arm64 build?

mor wrote:

Roguish wrote:

Rod,
aren't you following what Seb K is doing????

buildbot2.highlab.com

 
 
 
Any chance for an arm64 build?

See: forum.linuxcnc.org/18-computer/48113-odr...raspberry-pi?start=0
This is still a work in progress and I'm off on a holiday at the end of this week so nothing much more will happen until after Easter.