Installing LinuxCnc 2.8.0 Booster

Hey guys!
When I install LinuxCNC Wheeze everything goes fine.
When I run LinuxCNC Booster 2.8.0 or 2.8.2 or 2.8.4 as live disc - everything is fine. The network is working, the Internet is working. But when I install these versions - the installation stops at 'network configuration'. Where is the problem?

Use Debian BookWorm 12, it should be pinned at the top.
-
If you want to use Buster or Wheezy, when installing choose "continue without networking", or similar.

I had installed Debian 12 - unfortunately LinuxCnc was not there. And in general, the interface there is ugly and inconvenient!

To install LinuxCNC on Debian 12 you only need a single line in a terminal
sudo apt update
sudo apt install linuxcnc-uspace
Well, 2 lines
What DE did you try? XFCE? Mate? Gnome? Cinnamon?
Wheezy and Buster use XFCE, it is not good looking but it works.

I have a Dell Optiplex 760. www.itechguides.com/product-specs/dell-optiplex-760-specs/
It supports 64 bit system. What would you recommend - XFCE? Mate? Gnome? Cinnamon?

<4GB of RAM = XFCE
>4GB of RAM = Mate
>8GB with good graphic card = GNOME or Cinnamon

Great thanks!