about:./configure --with-realtime=uspace

Cant do this anymore bye all wrote:

嗯，这很有趣。

我安装了python3，这是运行检查您失败的行，我添加了python3位，原始行是

Code:

if $PYTHON -c "import gi;gi.require_version('Pango', '1.0');from gi.repository import Pango"; then . [code]python3 -c "import gi;gi.require_version('Pango', '1.0');from gi.repository import Pango" was ok [code]python -c "import gi;gi.require_version('Pango', '1.0');from gi.repository import Pango" failed After linking /usr/bin/ptyhon3 to /usr/bin/python [code]python -c "import gi;gi.require_version('Pango', '1.0');from gi.repository import Pango" was ok  What does [code]python --version[/return] ? Does Buster have both python3 & python2.x installed ? yes.I have python2.x &python3.x   [attachment=55914]20230912132341.png[/attachment]  

[/code][/code][/code][/code]

rodw wrote:

I would recommend you build linuxcnc on a Bookworm installation. 
I built an installer which do it all for you.
This will include linuxcnc 2.9 installed as a deb but that is the whole point of the rip-environment command. It will override the 2.9 settings while that window is opened.

If you do build 2.9 debs, I always first uninstall what is there 
sudo apt remove linuxcnc-uspace linuxcnc-uspace-dev
Then reinstall the new ones you built (replace the x's with the full deb name with cut and paste)
sudo dpkg -i linuxcnc-uspacexxxxxx
sudo dpkg -i linuxcnc-uspace-devxxxxxx

 

Cant do this anymore bye all wrote:

For anyone listening in which was the last version of Linuxcnc to build against python 2.7 ?