Getting an error when using gmoccapy.

I'm not quite sure what caused this error. Are there any solutions or suggestions?

 

Why can't I post my error log?

Do you also get an error if you load one of the gmoccapy simulation configs?

Only the simulator named gmoccapy can display the interface normally; the others cannot.

Odd, did you install on debian bookworm?

I built 2.9 from source just yesterday and gmoccapy works just fine.

It is Debian Bookworm, and mine was not built from the source code, but directly installed via apt

I forgot, you may have more luck with an updated version of linuxcnc since the one that is in the debian repo is fairly dated by now.

See section 9 in this document:

linuxcnc.org/docs/devel/html/getting-sta...etting-linuxcnc.html

I have been paying attention to this, but my device is arm64.

It appears you have an error with a file nme in the display section of your ini file[DEFAULT.QTVCP.QT_ISTAT][WARNING] Path not valid in INI File [DISPLAY] PROGRAM_PREFIX section (qt_istat.py:91

I temporarily resolved this issue, which was caused by a configuration file error. Now, I'm facing a new problem with my development board, which has an interface similar to the Raspberry Pi's 40-pin GPIO header. I noticed the Orange Pi project from allwincnc, where they use ARISC drivers to control the 40-pin GPIO pins. However, I couldn't find any relevant usage documentation in the LinuxCNC documentation. Could you provide me with some guidance?Here is the definition of the 40-pin interface on my development board: