XHC-WHB04B-6 and LinuxCNC 2.9.1

Looks like the error is a signal name mismatch:

pncconf uses net machine-is-on   but the XHC file uses net machine.is-on  

UGH!!!
You are 100% correct. I did not spot that variance (glasses???). OK! I can confirm hal works as expected after the edit. I am now going to go through the other errors I saw initially - I bet they are the same mismatches.
Thanks!

PCW wrote:

Looks like the error is a signal name mismatch:

pncconf uses net machine-is-on   but the XHC file uses net machine.is-on  

Twice i searched for typos and missed this... i need thicker glasses, or more sleep

There _is_ a way to test for signals with just one pin
in hal but I have forgotten how this is done...

When i start this pendant must push continuous mode button for jogging with
wheel is not press continuous it changes feedrate override.
How can fix this ?