LinuxCNC 2.9.1 installation from USB

More
2 years 10 months ago #289106 by szatri
LinuxCNC 2.9.1 installation from USB was created by szatri
Hello, I created a USB installation disk using rufus. After starting the installation, I have a problem with the CD-ROM, I don't want to install from CD, the installer does not allow it.

Please Log in to join the conversation.

More
2 years 10 months ago #289113 by Mecanix
Replied by Mecanix on topic LinuxCNC 2.9.1 installation from USB
In Rufus, after clicking "Start", select "Write in DD Image mode".
gl. 

Please Log in to join the conversation.

More
2 years 10 months ago #289128 by tommylight
Replied by tommylight on topic LinuxCNC 2.9.1 installation from USB
When you get the first error, unplug the USB, wait 3 seconds, plug it back in, wait 10 seconds, select "yes" and continue.

Please Log in to join the conversation.

More
2 years 10 months ago #289149 by rodw
Replied by rodw on topic LinuxCNC 2.9.1 installation from USB
Can you try using Balena Etcher to burn your USB stick?  Rufus does some funny things.

Please Log in to join the conversation.

More
2 years 10 months ago #289157 by szatri
Replied by szatri on topic LinuxCNC 2.9.1 installation from USB

When you get the first error, unplug the USB, wait 3 seconds, plug it back in, wait 10 seconds, select "yes" and continue.
it works, thank you for your help

Please Log in to join the conversation.

Time to create page: 0.086 seconds
Powered by Kunena Forum