linuxcnc2.9.2 RackTool Change

Hello,

After installing LinuxCNC 2.9.2 Debian 12 Bookworm PREEMPT-RT ISO can't use rack tool change (works ok with linuxMint with linuxcnc 2.9.0)

My config don't work and SIM RackToolchange don't work. 

What can be the problem?

Best Regards,
Marco Gaspar

initialize: module '/home/mjg/linuxcnc/configs/MJG_CNC/python/toplevel.py' init failed:
Traceback (most recent call last):

File "/home/mjg/linuxcnc/configs/MJG_CNC/python/toplevel.py", line 1, in <module>
import remap

File "/home/mjg/linuxcnc/configs/MJG_CNC/./python/remap.py", line 1, in <module>
from stdglue import *

ImportError: bad magic number in 'stdglue': b'\x03\xf3\r\n'

I think this can be caused by incompatible .pyc files so I would delete all the files with .pyc extension in your config folder and try again.

Hello,

But trying the linuxcnc SIM racktoolchange it don't work.

Ah yes. Does the SIM racktoolchange also give you the same error?

gtk-builder-error-quark: racktoolchange.ui:10:34 Invalid property: HAL_Table.n_rows (11)

Embeded tab command "halcmd loadusr -Wn gladevcp gladevcp -c gladevcp -d -x 58720399 racktoolchange.ui" exited with error: 1
Shutting down and cleaning up LinuxCNC...

This points to the glade file 'racktoolchange.ui' but your config does not seem to use that glade panel, does it?
If it does not use it then your machine config is likely failing for another reason. Have you tried deleting the .pyc files in the python folder of your config?

After copying the files on the simRacktoolchange to my config folder i get "pycall(remap.change_prolog) failed"

Hi, I'm facing the same issue. The difference is, I have not used racktoolchange before, I'm already trying to implement it into my machine. Any luck with it?