Deckel FP4A

   Hello, I'm new to the forum. If possible, I would like help with a parameterization problem. I installed, LinuxCNC2.8 to drive a Deckel FP4A I kept activated the boch Tr15 two-axis dimmer and stepper motor siemens of the time I integrated a leadshine motor and servo motors for the Y axis that is not yet activated.For this I set up a 6i25 7i77 in daughter card 7i78 I flachė all this with 5i25_7i77_7i78.bit successfully.On TB5 are connected and active the XYZ channels of an EXE 805 heindenhane also connected to optical measurement rules.Now Linux, CNC can't display the movements. I have the impression that it is still in demo and that it does not take into account the movement signals. I still have not connected the 7i77 output pins.The emergency stop loop is preserved and operational.Maybe I would have to connect all the relays to activate the axes?Excuse me for this translation from French to English.Thank you very much for your help.I can always give you other information if necessary.Sincerely.Eugene 

Use PncConf to create a new configuration for your machine with 5i25 and 7i77, save, start that config.
Probably will need more editing and tuning, so have a look here, plenty of info on how to wire, test, and tune:
forum.linuxcnc.org/10-advanced-configura...ning-detailed-how-to

Merci beaucoup je vais m’y employer il me faut une marche à suivre pour ne pas faire n’importe quoi.
Je vous tiendrai informé dès que possible des résultats.
Encore merci .
Eugène

bonjour .
hello there I followed the instructions given but my DRO remains inactive however the coders are well taken into account attached to the photo of the open page. I'm stuck at this level

Upload the hal and ini files here so we can have a look.
Do the numbers move on screen when you move the motor by hand?

  oui ils bougent etb meme dans les bons sens et-. voici mes fichiers ini et hal.merci 

Not good, there is nothing about 7i77 and encoders in those files, just 5i25 with stepgens.
Use the PncConf wizard to create a config for 5i25 with 7i77.

hello i come back after several inconclusive tests and with almost always the the same message see photo attached

Those errors look like you selected a 5I25+7I76 configuration in pncconf
(the error is because the 7I76 configuration enables 5 stepgens
 and you only have 4 in the 7I77+7I78 firmware)

As tommylight said, you should chose 5I25+7I77 in pncconf.

Then get that part working before tackling the 7I78 part

Thanks for your feedback I no longer know what to put on connectors 2 and 3 on N2 8i20 amplifier card and I have no corresponding card