Axis test OK but only Y-axe is working

dirver
Topic Author
New Member

2 years 4 months ago #302900 by dirver

Axis test OK but only Y-axe is working was created by dirver

Dear all,I'm new with Linuxcnc and installed the latest version.Stepconf wizard runs OK, including all axis.But when I want to move all the axis in Linuxcnc only the Y-axe moves, the other axis do nothing.Any idea ?Regards,Dirk

Attachment not found

Please Log in to join the conversation.

tommylight
Offline
Administrator

2 years 4 months ago #302912 by tommylight

Replied by tommylight on topic Axis test OK but only Y-axe is working

That is very weird pinout for anything, so what is the parallel port attached to?

Please Log in to join the conversation.

dirver
Topic Author
New Member

2 years 4 months ago #302922 by dirver

Replied by dirver on topic Axis test OK but only Y-axe is working

first (and only) parallelport p0
weird pinouts? This is my first Linuxcnc-installation ever, so I just followed the stepconf-wizard

Please Log in to join the conversation.

Time to create page: 0.072 seconds