I think those Trixie files may have been built on Bookworm, when I built an image last night it pulled the Linuxcnc packages from Debian. Trying to manually install brought up a lot of messages regarding packages that could not be installed.
Code:
sudo apt install linuxcnc-uspace=1:2.9.6 linuxcnc-uspace-dev=1:2.9.6
Solving dependencies... Error!
Some packages could not be installed. This may mean that you have
requested an impossible situation or if you are using the unstable
distribution that some required packages have not yet been created
or been moved out of Incoming.
The following information may help to resolve the situation:
Unsatisfied dependencies:
linuxcnc-uspace : Depends: python3 (< 3.12) but 3.13.5-1 is to be installed
Depends: libboost-python1.74.0 (>= 1.74.0+ds1) but it is not installable
Depends: libboost-python1.74.0-py311 but it is not installable
Depends: libgpiod2 (>= 1.5.1) but it is not installable
Depends: libpython3.11 (>= 3.11.0) but it is not installable
Recommends: hostmot2-firmware-all but it is not installable
Error: Unable to correct problems, you have held broken packages.
Error: The following information from --solver 3.0 may provide additional context:
Unable to satisfy dependencies. Reached two conflicting decisions:
1. linuxcnc-uspace:arm64=1:2.9.6 is selected as an upgrade
2. linuxcnc-uspace:arm64=1:2.9.6 Depends python3 (< 3.12)
but none of the choices are installable:
[no choices]
Andy is working hard on this, He's got a longer key now for trixie. you could try this script he did for trixie
www.linuxcnc.org/linuxcnc-trixie-install.sh
But he wants to produce a singe script that does all Debian versions....
The image builds with the longer Trixie key, I've also migrated to the newer form for the sources list.
The only package that will update from the Linuxcnc repo are the docs. So it works, the only issue being the one mentioned in my previous post.
