Delta Servo position register.

More
4 years 9 months ago #231051 by andypugh
Replied by andypugh on topic Delta Servo position register.

Code:
    px1 = (uint16_t)(xtemp)&;(0xFFFF); }

I just put the code in code-tags, and I think that there might be a spurious ";" in the line above.

Please Log in to join the conversation.

More
4 years 7 months ago #238361 by medicusdkfz
Replied by medicusdkfz on topic Delta Servo position register.
Hi Serdar,

I want to use 5 ASD-A2-M servos with EtherCat (EK1100 and EL6751). Could you help me please with my setup in LinuxCNC?

Thank you,
Pierre

Reply at: pierre(at)branitzki.de

Please Log in to join the conversation.

More
4 years 7 months ago #238366 by tommylight
Replied by tommylight on topic Delta Servo position register.
3

Please Log in to join the conversation.

More
4 years 3 weeks ago #253770 by steals2k
Replied by steals2k on topic Delta Servo position register.
Hello, Markus
Can I ask u about some help with 3rd gen and linuxcnc?

Please Log in to join the conversation.

More
3 years 10 months ago #258561 by mehdidadash
Replied by mehdidadash on topic Delta Servo position register.
I am afraid that M series of Delta servos use DMCNET and you can't use them with Ethercat

Please Log in to join the conversation.

More
3 years 10 months ago #258563 by medicusdkfz
Replied by medicusdkfz on topic Delta Servo position register.
Sorry, I was wrong: Of course it‘s the E-type…

Please Log in to join the conversation.

Time to create page: 0.049 seconds
Powered by Kunena Forum