Ethercat Salve

when i type ethercat slaves, nothing shows, and it cannot recognize the slave when i type ethercat master. any help is appreciated
(venv) abdulkareem@debian:~$ ethercat master
Master0
  Phase: Idle
  Active: no
  Slaves: 0
  Ethernet devices:
    Main: 94:e7:0b:28:c9:1d (attached)
      Link: UP
      Tx frames:   4528
      Tx bytes:    271680
      Rx frames:   0
      Rx bytes:    0
      Tx errors:   0
      Tx frame rate [1/s]:    124    116     56
      Tx rate [KByte/s]:      7.3    6.8    3.3
      Rx frame rate [1/s]:      0      0      0
      Rx rate [KByte/s]:      0.0    0.0    0.0
    Common:
      Tx frames:   4528
      Tx bytes:    271680
      Rx frames:   0
      Rx bytes:    0
      Lost frames: 4528
      Tx frame rate [1/s]:    124    116     56
      Tx rate [KByte/s]:      7.3    6.8    3.3
      Rx frame rate [1/s]:      0      0      0
      Rx rate [KByte/s]:      0.0    0.0    0.0
      Loss rate [1/s]:        124    116     56
      Frame loss [%]:       100.0  100.0  100.0
  Distributed clocks:
    Reference clock:   None
    DC reference time: 0
    Application time:  0
                       2000-01-01 00:00:00.000000000

 

Moved to "EtherCAT" section.

Do you have ethercat slaves installed? eg connected via the ethercat network cable?
If not plesae review the instructions in the sticky carefully. 
forum.linuxcnc.org/ethercat/45336-etherc...-how-to-step-by-step
Is /etc/ethercat.conf

correctly set up with your mac address.
What does dmesg say?

Thank you, problem solved. KERNEL=="EtherCAT[0-9]", MODE="0777" was masking the mac address