lcec config exited without becoming ready

More
1 year 8 months ago #320481 by Millimetergott
lcec config exited without becoming ready was created by Millimetergott
Hallo zusammen, ich bin grade dabi meine erste Maschine mit ethercat zubauen. Nach ein paar kleinen Fehlern hab ich das meiste beseitigen könne nun bekomme ich beim satrten der Sim axis diesen fehler: "lcec config exited without becoming ready".

Kann mir einer weiterhelfen ?

Gruß Tom

Please Log in to join the conversation.

More
1 year 8 months ago #320491 by Hakan
Replied by Hakan on topic lcec config exited without becoming ready
That's not right
Code:
<master idx="0" appTimePeriod="1000000" refClockSyncCycles="1">     <slave idx="0" name=”D1” type="EK1100"/>     <slave idx="1" name=”D2” type="EL2004"/>     <slave idx="2" name=”D3” type="EL2004"/>     <slave idx="3" name=”D4” type="EL1008"/>   </master> </masters>

You should add a new first line so it starts with
Code:
<masters> <master idx="0" appTimePeriod="1000000" refClockSyncCycles="1">

 (I hope you understand my answer, my german is terrible)

Please Log in to join the conversation.

More
1 year 8 months ago #320504 by Millimetergott
Replied by Millimetergott on topic lcec config exited without becoming ready
thx for your fast reply. I have chnged my configs like your exmaple, now i get a new error.

Please Log in to join the conversation.

More
1 year 8 months ago #320506 by Hakan
Replied by Hakan on topic lcec config exited without becoming ready
Is the config file really located there?
Code:
loadusr -W lcec_conf /home/tom/linuxcnc/configs/ethercat-conf.xml

Normally there is a sub-directory to configs, like
Code:
loadusr -W lcec_conf /home/tom/linuxcnc/configs/My_Machine/ethercat-conf.xml

Please Log in to join the conversation.

More
1 year 8 months ago #320517 by Millimetergott
Replied by Millimetergott on topic lcec config exited without becoming ready
Changed this part also but i get the same error again
 

Please Log in to join the conversation.

More
1 year 8 months ago #320530 by Hakan
Replied by Hakan on topic lcec config exited without becoming ready
Do you use some special double-quotes around D1, D2,D3 and D4?
Replace them with the normal ones, that are around 0,1,2,3 in slaves
names="D1"

Please Log in to join the conversation.

More
1 year 8 months ago #320762 by Millimetergott
Replied by Millimetergott on topic lcec config exited without becoming ready
I made a new xml with only the beckhoff EK1100. Now i get a new error

Please Log in to join the conversation.

More
1 year 8 months ago #320764 by Aciera
Replied by Aciera on topic lcec config exited without becoming ready
Change quotes around D3 (note the different appearance when you try to open the attached XML):

 

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.102 seconds
Powered by Kunena Forum