Issues with EtherCAT linuxcnc driver installation

More
1 year 8 months ago #322679 by Abdulkareem
Issues with EtherCAT linuxcnc driver installation was created by Abdulkareem
I got a new pc setup and tried downloading ethercat i followed the guide thats on the forum but i keep getting this error any help would be greatly appreciated

Please Log in to join the conversation.

More
1 year 8 months ago #322680 by Abdulkareem
Replied by Abdulkareem on topic Issues with EtherCAT linuxcnc driver installation
Ethercat on its own works fine a reads the slaves the issue is with the driver i think

Please Log in to join the conversation.

More
1 year 8 months ago #322682 by Abdulkareem
Replied by Abdulkareem on topic Issues with EtherCAT linuxcnc driver installation
i tried re installing again and now i have this new error instead

Please Log in to join the conversation.

More
1 year 8 months ago #322687 by rodw
Replied by rodw on topic Issues with EtherCAT linuxcnc driver installation
I think there is an error where you load your xml file in hal
Do you have this in hal?
loadusr -W lcec_conf ethercat-conf.xml
loadrt lcec

Please Log in to join the conversation.

More
1 year 8 months ago #322689 by Abdulkareem
Replied by Abdulkareem on topic Issues with EtherCAT linuxcnc driver installation
i do have both of these lines in my hal file

Please Log in to join the conversation.

More
1 year 8 months ago #322701 by Abdulkareem
Replied by Abdulkareem on topic Issues with EtherCAT linuxcnc driver installation
what else should i check for

Please Log in to join the conversation.

More
1 year 8 months ago #322716 by Hakan
Replied by Hakan on topic Issues with EtherCAT linuxcnc driver installation
Did you install linuxcnc-ethercat? The error says it is missing lcec, linuxcnc-ethercat.

Please Log in to join the conversation.

More
1 year 8 months ago #322764 by SteveCap
Replied by SteveCap on topic Issues with EtherCAT linuxcnc driver installation
Hakan, This appears exactly as the issue I am having. I can say that I also have linuxcnc-ethercat installed from the repo. Also I would have just posted here if I knew his error was the same, sorry for clogging things up.

Steve Cap

Please Log in to join the conversation.

More
1 year 8 months ago #322770 by Hakan
Replied by Hakan on topic Issues with EtherCAT linuxcnc driver installation
It mentions a filename vartokins.py, I don't have that here so I don't know what that is.

Please Log in to join the conversation.

Time to create page: 0.161 seconds
Powered by Kunena Forum