ASDA-A2-1521-E parameter list for ethercat com

Hi all is there a friendly soul out there, that have a parameter file ..? I can´t seem to get the RJ45 ports "online" like i have not made the right setup. i can connect to the drive via usb without any problems.

Best regards

With ethercat master installed it should be to just plug in the network cable, power on and the drive will show up in the "ethercat slaves" list, at least after "ethercat rescan".
If not, make sure the ethercat master is functioning "ethercat master -v" should show a lot of non-zero numbers.

thx i thought the light would be on, and flashing while communicate. i just connected them to the ek1100 and no faults