It's hard to give you a hand, as you are very spartanic with your Infos.
Code:
net probe-in <= parport.0.pin-13-in-not
net probe-in => motion.probe-input
Is in your hal file, does HalShow react if you push the tool sensor by hand?
Is parport.0.pin-13-in-not active when the probe is pushed or inactive?
Have you connected the gmoccapy toolchange hal pin in your postgui hal file, like mentioned in the documentation?
Code:
net tool-change gmoccapy.toolchange-change <= iocontrol.0.tool-change
net tool-changed gmoccapy.toolchange-changed <= iocontrol.0.tool-changed
net tool-prep-number gmoccapy.toolchange-number <= iocontrol.0.tool-prep-number
net tool-prep-loop iocontrol.0.tool-prepare <= iocontrol.0.tool-prepared
Norbert
