Charge Pump

I upgraded to Linuxcnc 2.7.4 using the Debian Wheezy .ISO and i'm running Gmoccapy and when I set up the charge pump it does not work so I set up a test mill in Axis and copied the config in the .INI over to Gmoccapy and it still does not work, I checked the HAL files and there was nothing to copy over so I think I got everything, so why does it not work in Gmoccapy but works fine in Axis?

Thanks
Orson

Please post both config folders, the gmoccapy and axis, so we can try to help.
I doupt it is caused by gmoccapy.

Norbert

here is the config files for both machine set ups.

Thanks
Orson

I took a look and found:

- Base and servo periods are different in both configs
- connection of charge pump in hal are different

Please use for gmoccapy and axis the same Base and Servo periods and the same connections in the hal files.

Then report.

Norbert

Yep, that works maybe next time I will pay more attention to what I'm doing. I missed two lines in the hal file, but now it works.

Thanks for taking the time to help me out.