halui.spindle-override.increase bug ?

I asked in Topic Hal .
Am I wrong or is it a bug .
I use button halui.spindle-override.increase , halui.spindle-override.decrease
Spindle speed blink

I have the exact same problem and just posted about it today. ( forum.linuxcnc.org/forum/gmoccapy/29928-...set-jog-speed-how-to )

Thank you for making video.

And I tested with sim and I am not able to reproduce that.

I am sure both of you have additional settings influencing the spindle, but without config, I am not able to check that.

Norbert

Hi Norbert ,
for example ( video ) standard configuration with Stepper Configuration Wizard for Parallel Port .
Then I made buttons in Glade for test ;
ini : custom1.hal it does not affect......0.001 or 0.1 .......
that is all
P.S. Unfortunately, at this time I have only Windows , no Debian Linuxcnc

This is my test config files, and here it does work!
What version of gmoccapy do you run?

Norbert

Hi Norbert

What version of gmoccapy do you run?

www.linuxcnc.org/linuxcnc-2.7-wheezy.iso
update 2.7.7
Please test the attached configuration .
After switching ,Run spindle, press Increase button

newbynobi wrote: This is my test config files, and here it does work!
What version of gmoccapy do you run?

Norbert

Norbert,

LinuxCNC 2.7.7
gmoccapy 1.5.6.4

I tried your files and I have the same problem.

Video:

I have attached my config folder (with your glade panel).

Hi,

I had a look at your files and couldn't find the reason, but i is probably caused from the VFD component, as the pins seems to work when spindle is off

Someone here to help finding the reason? I do not have spindle feedback and no VFD on my machine, i miss some harware to finish that part.

What hapen, if you change the override to 120 and start afterwarts the spindle?

Norbert (will be out for about a week)

but i is probably caused from the VFD component

There is no VFD component

Please test the attached configuration

TestSpindle #80919

YEEESSSSS!

I got it!
And solved that one, the bug was already in 2.6, so it is quiete old. Thanks to insist to solve that one.
I pushed the bugfix to 2.6, 2.7 and master!

If you need to repair 2.7 (only this one!) right now, please take the attached file, rename it to be gmoccapy without extension and replace the file gmoccapy in /usr/bin/
Owner should be root and group also root, the file must be executable.

or use buildbot 2.7.

Of course make a backup copy of the original file

Norbert