Auto Tool Measurement with different Positions

Can i promt an input dialog, so that I can specify the offset?

As far as I know, not directly from g-code.
You may be able to use a M100 command and call with that one a shell script.
Or you change the complete remap code to be a python remap and call the popup with python.

I have never done that, so I am not the best person to ask:( .

Norbert

First thank you for your work on changes made to include diameter of tool as offset for tool measure.

Question would it work if there was an included IF/then statment, so as to only offset tool from center of tool probe if the diameter of tool is bigger than tool probe diameter?