Gmoccapy backtool lathe

I'm using Gmoccapy interface for my lathe and I'm busy setting everything up. Once lathe mode is actived the jog buttons for X- and X+ should switch if you press the 'Y" button for backtool lathe.

So X+ is at the top of the jog panel, and - and the bottom. Lathe mode is working fine. But the jog buttons don't switch. They work perfectly fine though. But this is a bit confusing.

No, that is not correct!
If you use a backtool lathe, you need to set that in yor INI file!

Norbert

Hi Norbert
How should I set it?
Lathe = 1 is configured to active lathe mode
linuxcnc.org/docs/html/gui/gmoccapy.html#gmoccapy:lathe-section
But how do I set backtool mode?

Hallo timmert,

I should put that information also in the section you mentioned,

Please see Section 4.1

Norbert

Thanks Norbert!