Arrows for jogging not enabled

Hello,
I use AXIS for my Cincinnatti Arrow 500.
I want switch to Gmoccapy, but the arrows on keybord dont jog with machine.
How and where I can configure this (in Gmoccapy)?

I use LinuxCNC 2.7.1 and Cmoccapy 1.5.8

Thanks.

I am not polite, but have you taken a look in the documentation?

Just go to the settings page and enable "use keyboard jogging"

Norbert

P.s. if that does not solvevthe problem, post your config folder and i will look!