newbynobi wrote: you can change the complete behavior, just editing the change.ngc file.
Norbert
Like I said, pretty bad with Gcode at the moment. Actually I went through the extra steps to get a good measurement from my table to the top of the fixed vice jaw, now I just add or subtract the height of the work in the vise from that static measurement.
I didn't get a chance to look at the change.ngc file, but I was also wondering if there is a way to alter the behavior of the probing routine when an M6 is requested on the same tool that is already in the spindle. FreeCAD puts an M6 in every operation. Without touch probing set up, an M6 on the same tool will raise the spindle and go back to work. With touch probing the M6 will cause it to probe even if the tool wasn't changed. This takes up a bit of time on a column mill because the tool length varies so much I have to keep the search speed low.
Is there a way to modify this behavior or would it be better to replace the M6 on the same tool with a G53 G0 Z0 or something like that?
