How To use the Over Travel signal to stop tool measurement

Hi All,
I like to use the over travel signal of my tool probe to stop the Tool measuring process and use MAXPROBE only to prevent a crash in to Z-.
Is this possible an how can I set this up?
I'm still new to GmocCapy and like to get some help with that.

Thank you all in advance,
Denis

You can connect the over travel signal to the estop signal.
This is not gmoccapy related, it is just a hal matter.

Regards Norbert

You are right that I can connect it to the e-stop, this is what I already do.
I wanted to only abort the probing cycle and not stop the whole machine. Similar to the MAXPROBE implementation.
Thanks,
Denis

Try halui.abort
linuxcnc.org/docs/2.7/html/man/man1/halui.1.html