Bottom buttons chopped off in window mode

I like this interface but in window mode my monitor is chopping the bottom half of the bottom button row off. I tried to adjust the monitor settings and resolution and it doesn't help.

In full screen mode it is fine but I have no idea how to exit full screen mode. may have to try a different monitor ( it's currently a19” insigia TV)

What interface?
TV's have low resolution, so that might be the reason.

A 19" Monitor should have a resolution of 1280x1024, so that must be fine!
Can you post a screenshot, as that behavior is very strange on larger resolutions than 800x600

What resolution is given for window mode in the settings page?

You can leave fullscreen, going to the settings page and change the mode or just using ALT TAB if another window is open!

Norbert

newbynobi wrote: A 19" Monitor should have a resolution of 1280x1024, so that must be fine!
Can you post a screenshot, as that behavior is very strange on larger resolutions than 800x600

What resolution is given for window mode in the settings page?

You can leave fullscreen, going to the settings page and change the mode or just using ALT TAB if another window is open!

Norbert

I set the menu bar to auto hide and was able to drag the window up enough see it whole.

I'll have to check out those settings

Is there a way to reverse the keyboard jog direction? I want to reverse x and y

Leon82 wrote: Is there a way to reverse the keyboard jog direction? I want to reverse x and y

Why ??
X- will jog you x axis in negativ direction and X+ in positive!
I do not undestand the reason, but most easy way would be to changevthe order in gmoccapy.glade?

Norbert

newbynobi wrote:

Leon82 wrote: Is there a way to reverse the keyboard jog direction? I want to reverse x and y

Why ??
X- will jog you x axis in negativ direction and X+ in positive!
I do not undestand the reason, but most easy way would be to changevthe order in gmoccapy.glade?

Norbert

I just want To swap the keyboard. My left arrow makes the table go right. And up arrow makes y come forward

This may be normal, I'm used to an mpg at work.

Where can I find that .glade file?
I ha e been looking at the pinned info and found this as a possible location

/src/po/gmoccapy

If you press the left button and your table moves right, all is OK, as always the tool direction is relevant, not the table!

If you want to change the glade file you do find that one in usr/share/gmoccapy

do not remove ore rename widgets, moving them arround is in most cases OK
Do not forget to backup

Norbert

newbynobi wrote: If you press the left button and your table moves right, all is OK, as always the tool direction is relevant, not the table!

If you want to change the glade file you do find that one in usr/share/gmoccapy

do not remove ore rename widgets, moving them arround is in most cases OK
Do not forget to backup

Norbert

If it's normal I'll leave it. I'm just going to have to get used to it.. thanks