Using gmopccapy with an XHC-HB04 pendant

Hi all,

I finally extended my gkmoccapy setup with an XHC-HB04 MPG Pendant. Following the instructions found on the forum, I have this working now and I programmed most buttons to my needs.
But a very basic question remains:
When gmoccapy presents a dialog or message on the screen, e.g. for a tool change, I still need to click the OK button on my screen. Would there be a HAL command I could issue from a button on my MPG in order to close that dialog in gmoccapy?
That would make live easier.

Thanks,
Frans

Not at the moment, but that is a good idea,
i will see, if i find time to include such a pin, i just use the enter button of my keyboard?

Norbert

Hi Norbert,
Thanks for the quick response (as always).
Would be nice if you could do something on this, obvious not in a hurry. However I am still on Linux 2.7, with GMOCCAPY 1.5.9....
But in case you know of a way that I can program a button definition in the pendant configs, to raise an "Enter" keyboard command, that would be good enough maybe.

Thanks,
Frans

Sorry for using an old thread but could you share your config files for gmoccapy and the pendant please?