Spindle ccw hanging

Hi,

It looks like you connected M5 to M4.

Grotius wrote: Hi,

It looks like you connected M5 to M4.

Where do you see that? Its an auto generated config with only minor edits. Point it out and I'll change it.

Hi,

It was relativating ansfer. If everything go's out. It's problably a M5

# --- SPINDLE-CW ---
setp hm2_5i25.0.gpio.028.is_output 1
setp hm2_5i25.0.gpio.028.invert_output 1
net spindle-cw hm2_5i25.0.gpio.028.out

# --- SPINDLE-CCW ---
setp hm2_5i25.0.gpio.029.is_output 1
setp hm2_5i25.0.gpio.029.invert_output 1
net spindle-ccw hm2_5i25.0.gpio.029.out

Okey output 28 and output 29 is okey.
But after this you have a dot .
After the dot you have identical connection's.
There is no output 2.
Can this cause a problem? Hal will normally trigger a issue. But hal is problably not written out after the dot statement.

That HAL looks OK to me.

But: You are looking at signals. It would be useful to look at pins. Specifically motion.spindle-reverse.

andypugh wrote: That HAL looks OK to me.

But: You are looking at signals. It would be useful to look at pins. Specifically motion.spindle-reverse.

CW


CCW

Hi Andy,

He is doing set parameter i see now. I saw it as net command, i need glasses
The fastest way for him is to look in the list of gmocappy gui signals in HAL.
The Gpio list is problably a mesa list. If he looks for the gmocappy gui list in the same tabel. he can compare the
value's. Gmocappy has also a output pin for M4.

One odd thing I notice is that it is showing S550 and the reverse button.
When I try it here, it shows S -550 for reverse.

Do you have a minimum speed configured somewhere? (I see that the bottom number on the slider is 550)

I am wondering if, because -550 is less than 550, the GUI is refusing to command that speed.

If so he can do a mdi command : M4 S1
It must work normally.

Or press F10 and then F12 to increase the speed for reverse, F11 decreases speed while F9 turns the spindle CW.

andypugh wrote: One odd thing I notice is that it is showing S550 and the reverse button.
When I try it here, it shows S -550 for reverse.

Do you have a minimum speed configured somewhere? (I see that the bottom number on the slider is 550)

I am wondering if, because -550 is less than 550, the GUI is refusing to command that speed.

I'm scanning through config files looking for a minimum speed setting, any idea where it might be?