Is gmoccapy included in Release 2,7,14?

I loked on the iso file and found no indication that it is there.

Gmoccapy is included with Linuxcnc version 2.7.14 (I think it is version 1.5)

Newer versions of Gmoccapy are restricted to 2.8-pre and newer versions because maintaining the differences between the newer JA versions of Linuxcnc and 2.7 was not worth the effort.

PS: the Wheezy ISO does not have 2.7.14 it is 2.7.0. You must update after installing to get 2.7.14. (Not sure about the Stretch Preemt-RT ISOs they are likely more uptodate.)

Thanks for your reply, so if I want to use gmoccapy I will need to down load an older version of linuc an then update to 2.7.14

Buddy002 wrote: Thanks for your reply, so if I want to use gmoccapy I will need to down load an older version of linuc an then update to 2.7.14

No need to do that. Its included in V 2.7 but latest changes are only in V2.8. I would not think that is a limitation as if there was a major bug, I'm sure it would be fixed in 2.7

There are some fairly significant changes to Linuxcnc in 2.8 so I would not expect you could use the latest version in v 2.7. YO need to upgrade to V 2.8 instead.

I will give this a try